Blichton loamy fine sand and a shallow water table
North Brooksville isn't built on one ridge sand. USDA soil points sampled inside it spread across loamy, slower-draining units: Blichton loamy fine sand at 6 of 30, Nobleton fine sand at 4, Flemington fine sandy loam at 4 and Micanopy loamy fine sand at 3. Blichton and Flemington are poorly drained, Nobleton and Micanopy somewhat poorly drained, and NRCS rates 23 of the 30 points somewhat or very limited for homes without basements.
For concrete contractors in North Brooksville, here's what that means for a slab or foundation. Water sits close under the yard for part of the year, as close as about 15 cm on Blichton and 38 cm on Flemington. We dig a test hole at the estimate, build the pad up on clean, compacted base where the ground is low, and grade the finished slab to shed water away from the house and off the edges.
Crossroads lots on US 41, US 98 and SR 50A
US Hwy 41, US Hwy 98 and State Hwy 50A all cross North Brooksville, along with Ponce de Leon Blvd, State Hwy 581, Broad St and W Jefferson St. US 41 and US 98 are on Hernando's list of collector and arterial roads, and that list matters on rural land. On parcels zoned AG or Country 2.5 that front one of them, homes and accessory buildings must sit at least 125 feet back from the road. Off those two roads it's 75 feet. SR 50A isn't on the list, though State Hwy 50 is.
So a shop or pole barn slab on a highway-front parcel can land farther back than you'd first picture. That means a longer haul across the lot for the truck and sometimes a longer gravel or concrete approach. AG parcels also need 35 feet from side and rear lines, and Agricultural/Residential lots use a 50 foot front yard, 10 foot sides and a 35 foot rear.
A 30 by 40 pole barn slab runs $8,400 to $14,400 at $7 to $12 a sq ft. The pole barn slab cost guide shows what moves that, and barndominium foundations are quoted after we see the plans.
These are our typical ranges as concrete contractors in North Brooksville. Base on low ground, setback distance, thickness and steel set where yours lands.
| Job | Per sq ft | Typical project | What moves the price |
|---|---|---|---|
| Concrete driveway, 2-car (about 500 to 700 sq ft) | $8 to $14 | $4,000 to $9,800 | Tear-out, base on wet soil, length to the road |
| Concrete patio, plain or broom (about 240 to 400 sq ft) | $7 to $12 | $1,680 to $4,800 | Grade away from the house, steps |
| Garage, shop or shed slab (about 200 to 600 sq ft) | $7 to $12 | $1,400 to $7,200 | Mesh or rebar, thickened edges, termite treatment |
| Stamped or decorative (about 300 to 650 sq ft) | $12 to $22 | $3,600 to $14,300 | Pattern, color, sealer |
| Pole barn slab, 30x40 (1,200 sq ft) | $7 to $12 | $8,400 to $14,400 | Setback distance from US 41 or US 98, truck access |
| RV, boat or carport pad, 12x40 (480 sq ft) | $8 to $14 | $3,840 to $6,720 | Thickness for the load, built-up base |
Ranges only, with a free written estimate after we see the site. Hernando County permit fees, where a permit applies, appear as a separate line.


